in

Deliberant Support Site » Legacy Products » DLB50xx Series Radios » Dlb5000

Dlb5000

Last post Thu, Sep 13 2007 4:27 PM by DLB - Caleb. 1 replies.
Page 1 of 1 (2 items)
Sort Posts: Previous Next

  • Wed, Sep 12 2007 10:21 PM

    • zet
    • Top 500 Contributor
    • Joined on Wed, Sep 12 2007
    • Posts 1

    Dlb5000

    Reply Contact

    Guys,

    I have set up a 6 mile link with the 5023 radios 23 dbi antennas.. the signal seems to be good enought, but I cannot get more than 700kbs out of it

    its on a clear area with no obstructions or interference.. Any ideas on to how to get it to perform better?

    See below the configuration, It is meant to be a PTP not a MP link, any help would be appreciated.  I tried a few things like go to 54 mpbs without the auto speed on both sides and also packet bursting but it only seemed to make the link slower.

    Help!

    Zet 

     

     This is the AP side

    Enable radio
    Operating mode AP Client
    IEEE mode A
    Throughput enhancements Fast Frames  Packet Bursting  Compression  Dynamic Turbo -->
    SSID
    Broadcast SSID
    Current channel 165
    Channel auto149153157161165 Full Half Quarter
    Quality of service (WMM)
    Automatic data rate mode
    Data rate, Mbps 69121824364854
    Enable WDS

     

     

    Wireless Statistics

    Interface Status Link Level Noise Invalid network ID Decryption errors Invalid fragments Retry count Miscellaneous errors Missed beacons
     ath0  up  31  191  160  0  0  0  0  0  0

    Peers/Access-Points

    Interface Mode HW address Quality Signal level Noise level Data rate
     ath0  Master  00:80:48:4c:9e:c3  31  -64 dBm  -96 dBm  6 Mbps

    Radio Information

    Country  United States

    Interface MAC address IEEE mode Channel ESSID
     ath0  00:80:48:4C:83:BF  A  165  DLB5000

     

     

     This is the SU side

     

    Enable radio
    Operating mode AP Client
    IEEE mode A
    Throughput enhancements Fast Frames  Packet Bursting  Compression  Dynamic Turbo -->
    SSID
    Broadcast SSID
    Current channel 165
    Channel auto149153157161165 Full Half Quarter
    Quality of service (WMM)
    Automatic data rate mode
    Data rate, Mbps 69121824364854

     

    Status Link Level Noise Invalid network ID Decryption errors Invalid fragments Retry count Miscellaneous errors Missed beacons
     ath0  up  35  206  171  0  0  0  0  0  0

    Peers/Access-Points

    Interface Mode HW address Quality Signal level Noise level Data rate
     ath0  Managed  00:80:48:4C:83:BF  35/94  -50 dBm  -85 dBm  6 Mbps

    Radio Information

    Country  United States

    Interface MAC address IEEE mode Channel ESSID
     ath0  00:80:48:4C:9E:C3  A  165  DLB5000

     

  • Thu, Sep 13 2007 4:27 PM In reply to

    Re: Dlb5000

    Reply Contact

    Hi,

    I talked to you by phone, upgrading the firmware is what we need to do, then we can go from there.

    Caleb
Page 1 of 1 (2 items)
Copyright Deliberant LLC. All rights reserved.